Electra X620 Outlaw Bass *SOLD* / Make an enquiry

Tobacco Sunburst
V.Good 8/10

Back to overview
Make an enquiry

*SOLD*Vintage Electra X620 Outlaw bass guitar in very good condition. The body / headstock show only a small number of chips/dings. The back of the neck is clean. The frets show no signs of wear and there is plenty of movement left in the truss rod. The action is set nice and low. The hardware shows no rusting and only minimal oxidation. The bass comes with the original hard case!! ( sadly the handle is missing) Weighs 10.4lbs.

Neck-through mahogany Outlaw body design with Tobacco sunburst finish, silver hardware. MPC on board electronics. The neck is bevelled to allow access to all the frets high up the neck. Brass nut. Abalone \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\"bow tie\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\" position markers. Tone Spectrum circuitry allows 5 different pickup combinations. Die cast tailpiece ( Virtually identical to that of a Rickenbacker bass) All the hardware is of a very high quality reminiscent of other high quality American made instruments of the time. ( this bass was produced in Japan) The controls are as follows: The 2 dials neck side are volume and tine. The 2 bridge side are effect the intensity of the effect. The 2 switches turn on/off each corresponding effect. The effects are located behind the back panel and are interchangeable. ( the MPC effects units can be found here on Ebay) Currentlythe effects in this bass are 1 power overdrive and 1 phase shifter effect.